www.costway.com
www.costway.com
8.Do not use outdoors.
9.Do not let cord hang over edge or table or counter, or touch hot surfaces.
10.Do not place on or near a hot gas or electric burner, or in a heated oven.
11.Extreme caution must be used when moving an appliance containing hot oil
or other hot liquids.
12.Always attach plug to appliance first, then plug cord into the wall outlet. To
disconnect, turn any control to “off”, then remove plug from wall outlet.
13.Do not use appliance for other than intended use.
14.CORRECT USE OF ELECTRICITY
a)Use of an extension cord is not recommended as it may overheat and cause risk
of fire. However, if an extension cord is used, the marked electrical rating of the
extension cord should be at least as great as the electrical rating of the appliance,
and the long cord should be arranged so that it will not drape over the countertop
or tabletop where it can be pulled on by children or tripped over.
b)To prevent overloading and blowing fuses, ensure that no other high power appli-
ance is plugged into the same socket, or another socket which is connected in the
same circuit.
c)DO NOT PUT the cord under the carpet, blankets. Always keep the power cable
away from walkway in room.
d)DO NOT TRY TO REPAIR the broken fuse by yourself, the user should take the
set to your local authorized maintenance center to replace it with the new one.
e)The appliance is indoor use only.
f)This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and knowl-
edge, unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
g)Children should be supervised to ensure that they do not play with the appliance.
h)The surfaces are liable to get hot during use
i)Appliances are not intended to be operated by means of an external timer or
separate remote-control system
j)When the appliance is not in use and before cleaning, unplug the appliance from
the outlet.
k)WARNING: If the surface is cracked, switch off the appliance to avoid the possi-
bility of electric shock.
l)The outer surface may get hot when the appliance is operating and first time use,
there is a little smoke and smell, that is normal.
SAVE THESE INSTRUCTIONS
HOUSEHOLD USE ONLY
15.SAFETY IN OPERATION
a)
DO NOT OPERATE
this hot plate near water sources or flammable liquids.
b)
DO NOT OPERATE
this hot plate on or near any hot surface. (Hot plate,
electric stoves etc).
c)Always operate this from an earthed domestic 120V~60Hz power socket.
d)Ensure the hot plate is placed on a stable, secure surface to eliminate the possibil-
ity of tipping over or avoid any water in the appliance.
e)Never try to touch the hot surface of this hot plate before it is cooled down.
PREPARATION BEFORE USE
1.Clean the hot plate with a soft damp cloth. Place your hot plate on the level and
stable surface near the electrical socket.
2.Check that the voltage marked on the product corresponds with your supply
voltage. Ensure the controller is in the “OFF” position before plugging in.
3.Always use flat bottom saucepans or containers that make close contact with the
heating element. Ideally, the saucepans or containers should be 180
~
200mm (
7”-8”) in diameter. Keep the surface of the heating element clean and dry.
4. Close supervision is extremely necessary when this hot plate is used by or near
children or invalids. Never operate this hot plate unattended.
OPERATION
1.Put water and/or food in the container (The total amount of water and /or food
should not exceed 80% of the container to avoid overflowing), put a lid on the
container and place it on the hot plate. If there is smoke for the first use, that is
normal. To make the unit heat without any pot about 10 Minutes before cooking.
2.Connecting to the power supply socket. Turn the switch from “OFF” TO “MAX”
position and the indicator light is on for working, the hot plate is in a state of
heating.
3.Two points to be reminded by the user when using the new hot plate:
a)When using this hot plate for the first time, there may be a smell of smoke
coming from the surface of the heating element. This is normal because of the
invisible protective coating in production.
b)Before the water is boiling, the indicator light on the hot plate may be temporary
off due to the temporary disconnection of the thermostatic control. This is a safety
issue for the working on the hot plate.
4.When you have finished using the hot plate, turn the switch to “OFF” position
and unplug it from the socket. Wait until the appliance is completely cooled down
before moving or cleaning.
04
05