www.costway.com
www.costway.com
Maintenance
Lubricating
The running belt must be lubricated with the specialized silicone oil
after using for a period.
1.Recommended lubrication frequency : Using time is less than 3
hours a week Lubricate it every 5 month
Using time is 4-7 hours a week Lubricate it every 2 month
Using time is over 7 hours a week Lubricate it every month
It will not be better if it is over lubricating, but reasonable lubricating
can be an important factor to increase the life of treadmill
2.How to lubricate
To check whether your treadmill needs lubricating, you can hold the
running belt and put the other hand to touch the bottom center of the
running belt, if you can feel the wet silicone oil that means it does not
need lubricating. If you feel the running belt is very dry that means
your treadmill needs lubrication.
A. How to lubricate (as picture)
B.Stop and fold the treadmill
C.Raise the running belt on the base, then try to put the silicone oil
pot under the running belt and smear the silicone oil on the belt and
both sides of the treadmill, then set 1KM/H to make sure silicone oil
lubricates every well, you can step the running belt from left to right to
improve the lubricating effect.
running belt
running
board
silicone
oil
running
board
3.Adjusting the tightness of running belt
Every treadmill must set the tightness before it leaves factory and
after assembly, but it will become loose after using for a period.
Just like it will stuck or slide sometimes, you can turn the adjusting
bolt in clockwise direction, semi-circle a time (left and right at the
same time) to adjust the running belt. Don’t make it too loose or too
tight, or the running belt will slide or make motor over load.
4.Running belt deviating.
All running belt is in the right place when it is packaged. But there are
some factors will cause this situation.
1)The treadmill is not set flat
2)User does not step on the center of the running belt
3)Caused by 1 or 2 is easy to be solved, just set the treadmill flat
and let it idle for several minutes can solve the problem.
If the deviating still exists, you can use the 6mm Allen wrench to
adjust it in a quarter turn.
Deviating is not in the warranty scale, user can maintain it as
following instructions. But please fix it as soon as you find the
problem or it may break the running belt.
1.Running belt slipping: The running belt may slip or have unexpected stop in
working time
2.Adjust the belt: Adjust the screws around the belt in clockwise direction for 3
rounds, then adjust the belt as the belt deviation until the belt returns to the middle of
the base.
If deviating turns to right, then turn the
left screw in counterclockwise
direction,Turn the right screw in
clockwise direction.
Turn the left screw in clockwise
direction with Allen wrench.
Turn the left screw in counterclockwise
direction with Allen wrench.
If deviating turns to left, then turn the
left screw in clockwise direction,
turn the right screw in
counterclockwise direction.
18
19
