7). After inserting the rear end, move the front end of the armrest
close to the steel frame and hook the front end of the armrest
into the steel pipe of the seat frame (Figure 7).
8). After hanging up, press down on the armrest, press it in
place, and then push up the front end of the armrest. Place the
hook at the front end of the armrest close to the steel pipe, and
then shake the armrest lightly to check whether the front and
back ends of the armrest are in place (Figure 8).
9). Unzip the upper arm sleeve, and then use the cross-head
screw to fix cross-head screws through the hole of the space
capsule. Tighten it with the armrest, and then zip the upper arm
cover (Figure 9).
10). Align the mounting holes on the armrest, and then use the
cross-head screws to tighten the cross-head screws and fix
them on the armrest. Then the armrest is completed. The same
installation procedure to the other armrest(Figure 10).
Figure 5
Figure 7
Figure 6
Figure 8
Figure 7
Figure 8
Figure 9
Figure 10
Figure 9
Figure 10
21
Summary of Contents for JL10009
Page 29: ......
