Install 2 scorers E7 at both end sides
and fix with screws B2, 2 PCS per side,
4 PCS in total.
Make sure that the table is
balanced and use the tool C1 to
screw all nuts.
Turn the table upside down and
install the support beam E6 into
the bottom board.
Insert the support bar B3 into the
support beam E6, and fix with
washers B4 and nuts B5 at both
ends by the tool C2.
04
B6
E8
A
A
B
B
B
Install 4 table legs (E4 & E5) into
side boards. Tighten with screws
B1A at both short sides, 2 PCS for
each, 4 PCS in total. Tighten with
screws B1B at both long sides, 2
PCS for each, 4 PCS in total.
Install the handle A2 on one end
of each bar and make sure all the
handles are tightened.
