8
EN
G
LI
SH
Installation
Inserting batteries
Note:
Insert the batteries into all sensors before inserting batteries into the indoor unit. When
power is supplied to the indoor unit, an automatic search for nearby sensors will begin.
When inserting the batteries into the units, check the markings in the battery compartment
to ensure the correct polarity.
Anemometer
1. Remove the battery cover on the underside of the anemometer.
2. Insert 4 × AAA/LR03 batteries. The LED indicator will be illuminated for 3 seconds,
followed by continued flashing once every 16 seconds to indicate that data is
being transmitted from the unit.
3. If the LED indicator does not flash after the batteries have been inserted, reset
the sensor by pressing [ RESET ].
4. Replace the battery cover so that it clicks into place.
Remove
the product from
the packaging and
check that nothing
is missing
Insert batteries
into the sensors
(the transmitters)
Start the indoor
unit (the receiver)
and connect
the sensors
Make the settings
for the weather
station and check
that the sensors
are working
Mount the sensors
in an appropriate
location
