EN
G
LI
S
H
T I M E
S E N S
L U X
Functions
Light duration time setting
The length of time that the light comes on for after it has been activated can be set
from 10 seconds to 4 minutes. Adjust the time using the [TIME] dial.
PIR sensor sensitivity
Adjust the sensitivity using the [SENS] dial. Turning towards (-) decreases the
sensitivity; towards (+) increases the sensitivity.
Light sensor sensitivity
The wall light is fitted with a light sensor that reacts to ambient lighting conditions.
It turns the light on at night and off in the morning. Adjust the sensitivity from night-
time ( ) to daytime (
) using the [LUX] dial. The closer the (
) position, the lighter
the conditions have to be for the wall light to come on. The closer the ( ) position,
the darker the conditions have to be for the wall light to come on.
Settings
1. Set the light sensitivity dial [LUX] to (
) and the time dial [TIME] to (-).
2. Turn the power on and wait half a minute. The wall light will now come on for
30-60 seconds.
3. Adjust the direction of the light.
N.B.
Loosen the screws slightly when adjusting
the angle of the light.
4. Adjust the PIR sensor to the desired position. Get someone to walk across the
detection zone to detect when the light comes on.
5. Adjust the duration setting using the [TIME] dial.
6. Adjust the light sensitivity using the [LUX] dial. To set the light sensitivity, wait
until the lighting conditions are at the desired level and slowly turn the dial until
the light comes on.
