11
EN
GL
IS
H
Connecting the extension lead
1. Make sure that the extension lead is not connected to the mains.
2. Make a loop out of 20–25 cm of the extension lead and attach it to the cable
restraint (9) on the handle.
3. Tighten the loop over the cable restraint (9).
4. Plug the grass trimmer lead into the extension lead.
5. Plug the extension lead into a wall outlet when it is time to use the trimmer.
Switching the trimmer on
1. Hold down the safety switch (11) on the rear handle.
2. Start the trimmer by pressing in the power trigger (10).
3. Release the power trigger to stop the motor.
Care and maintenance
NOTE:
Always disconnect the plug from the power supply before cleaning, adjusting
or transporting the grass trimmer.
Changing the trimmer line
1. Open the trimmer head by
twisting the bottom, “the cover”,
anticlockwise and removing it.
The line spool can then be removed,
but take care not to lose the spring
located under the spool.
2. Take a new spool and line and make
sure that the line passes through
the notches in the spool and that
the ends of the line stick out about
15 cm to make fitting easier.