3
ENG
LI
SH
12. Use common sense and be careful.
- Think carefully before carrying out every action, so that it is carried out safely. Never operate machines/
power tools when you are tired or under the influence of medicine.
13. Inspect the tool for damage.
- Check the following before turning the tool on: that the guards and other parts are undamaged and
working properly, that moving parts can rotate freely and are correctly aligned, that no moving parts can
get caught, that there is no fault or defect that could affect the performance of the machine. A safety
guard or any other part that is damaged should be repaired by a tradesman or replaced. Damaged
power leads and switches must always be replaced by a tradesman. Never operate a tool if you cannot
stop or start the tool comfortably.
14. Warning! Use only recommended accessories.
- The use of non-recommended accessories can cause accidents and personal injury.
15. Power tools should only be repaired by a qualified technician.
- This tool conforms to current safety requirements. Repairs to the tool should only be carried out by a
tradesman using original spares; otherwise the tool could cause accidents and personal injury.
1.2 Safety instructions
• The spray gun must not be used in close proximity to sources of ignition such as open fires, smokers,
sparks, filaments, hot surfaces, etc.
• Be aware of potential hazards caused by the spray coating. Follow the instructions on the packaging of the
spray coating, especially those related to personal safety equipment.
• Use all chemicals in a well-ventilated room suited for the purpose.
• Warning! Never use a spray coating that you are unfamiliar with and do not know how dangerous it is.
• If the power lead is damaged, it must only be replaced by an authorised service centre.
•
Warning! Personal danger.
Never point the spray gun at yourself, other persons or animals.
• Make sure that no solvent fumes are sucked into the turbine when the spray gun is used indoors.
• Toxic fumes can be produced from working with the spray gun that could be hazardous to your health.
•
ALWAYS
use suitable safety goggles, gloves, breathing masks, etc. to prevent paint, solvents and
poisonous fumes from coming into contact with eyes and skin.
• Pay attention to the wind direction when using the spray gun outdoors. When working indoors, ensure that
there is adequate ventilation.
• Do not point the spray gun at the turbine.
• Never let children use the spray gun.
• Do not disassemble the product and do not try to repair it yourself.
2. Safety symbol guide
Wear ear protection.
Wear safety glasses or visor and a face mask.
Read the entire instruction manual before use and save it for future reference.
