Cotech OB-LR06-230/C, Original Instructions Manual

7

ENG

LI

SH

Operation

1.  Adjust the length of the telescopic shaft to suit your height.

Care and maintenance

Note 

Always remove the battery before cleaning, adjusting or transporting the tool.

Changing the trimmer line spool

1.  Remove the cover and spool by holding in the snap locks (one on each side) and pulling the cover and 

spool away from the mount. 

2.  Install a new spool and make sure that the tabs ands slots line up so that the spool goes all the way to  

the bottom of the cover. 

3.  Refit the cover and spool by holding in the snap locks (one on each side), lining the tabs on the cover up 

with the slots in the mount and pushing down. Make sure that the spring is positioned correctly and that  
the cover clicks into place.

4.  Push in the button in the middle of the spool and pull out some trimmer line if necessary. If too much line is 

pulled out it will be cut off by the knife on the edge of the line guard.

•  Regularly check that grass and twigs have not built up around the line spool.
•  Regularly check that the on/off switches and safety lock are undamaged and work correctly.
•  Clean the exterior of the tool with a soft brush or cloth. 
•  Do not use any water, solvents or polishes.
•  Regularly remove all dirt, especially from around the motor’s ventilation slits.
•  Store the tool in a safe, dry place out of the reach of children. 
•  Do not store the battery in temperatures below zero.

2.  Adjust the cutting angle by pushing in the pivot button (3) on  

the side of the trimmer head.

3.  There are three fixed positions.
4.  Press and hold in one of the trigger lockout buttons (8) on the rear 

handle and then press the trigger (7) to switch the trimmer on.

5.  New trimmer is fed out of the spool by bumping the trimmer head on 

the ground when the trimmer is on full power. The line is cut to  
the correct length by the knife on the line guard.