10
EN
G
LI
S
H
B. Function settings
Select the required application using the selector switch (4).
1. Rotate the switch away from
you in order to use the hand
tool as a rotary hammer when
drilling concrete or stone.
2. Rotate the selector switch towards
you in order to use the hand tool as
a power drill or power screwdriver.
C. Clockwise/anticlockwise rotation
• Clockwise/anticlockwise rotation can be selected using the changeover switch (8).
The power switch will be locked if the changeover switch is set to the mid-position.
The chuck must be completely stationary when you are changing the rotation direction.
• The rotation direction is indicated by indicator lights 6 or 7.
Clockwise (drilling and screwdriver functions):
Press in the selector switch (8) on the right-hand side as far as it will go and
check that indicator (6) illuminates when you press in the power switch.
Anticlockwise (removing screws):
Press in the selector switch (8) on the left-hand side as far as it will go and check
that the indicator (7) illuminates when you press in the power switch.
D. Starting, stopping and adjusting the RPM
• The tool can be started and stopped by pressing in and releasing
the power switch (9).
• The machine is equipped with continuously variable RPM adjustment, which
is a particularly useful feature when using the tool as a power screwdriver.
The further in that the trigger is pressed, the higher the RPM will be.
E. Advice and tips for drilling
• When drilling smooth materials such as clinker concrete, you should apply a piece
of heavy duty tape across the area where you intend to drill so that the drill bit does
not slide when you are drilling.
• When drilling metal, you should first use a centre punch and make a small hole
where you intend to drill. This small hole will then hold the drill bit in the correct
position so that it does not slide when you are drilling.
• When drilling metal, you should also use thread/cutting oil in order to protect the tool.
Summary of Contents for PLCT0301
Page 2: ...2 ...
