9
EN
GL
IS
H
Using the tool
1. Hold the tool firmly.
2. Press the tool against the work surface.
3. Press the trigger in and release it after firing.
4. Move the tool to the next spot and repeat.
Removing a nail that has become jammed
1. Disconnect the compressed air
from the air gun.
2. Open the magazine and remove the
jammed nail, and/or remove the three
screws that hold the front plate with
the provided Allen key.
3. Remove the outer and inner front plate.
4. Remove the stuck nail and replace
the front plate.
Trouble-shooting
Warning!
Always disconnect the compressed air before doing any work with the nail gun.
Air leaks from the gun.
• Check all screws and tighten with Allen keys.
The nail gun does
not nail or does so
sluggishly.
• Check all screws and tighten with Allen keys.
• Make sure that the nail gun receives the right
working pressure from the compressor (4–7 bar).
• Make sure there are no air leaks between
the compressor and the nail gun.
Nail jams in tool.
• Make sure the nails are the right size.
• Check that the nails are not damaged.
• Clean the magazine.
• Remove the front plate and clean it sniff check that
there is no damage.
Summary of Contents for XAGD50
Page 2: ...2...
