Cotterman CAL OSHA 6500 Series Assembly Instructions Download

Page: 3 / 3

0520001revB

©Copyright Cotterman

™ Co. 2011

3 OF 3

Division of Material Control, Inc.

STEP 4

– COMPLETION – (DRAWING C)

a) STAND LADDER UPRIGHT AS SHOWN.
b) MAKING SURE THE LADDER IS LEVEL AND ON THE RUBBER BUMPERS, TIGHTEN ALL

BOLTS.

DO NOT PROCEED UNTIL ALL BOLTS ARE SECURE AND THE LADDER IS STABLE!

DRAWING C

TO TAKE YOUR 6500 SERIES LADDER DOWN FOR TRANSPORT OR STORAGE, REVERSE

STEPS 3 AND 4.

THE LADDER MUST BE LAYED ON ITS SIDE TO DO THIS SAFELY

QUESTIONS OR INQUIRIES SHOULD BE DIRECTED TO:

COTTERMAN COMPANY

DIVISION OF MATERIAL CONTROL, INC.

P.O. BOX 168

CROSWELL, MICHIGAN 48422

PHONE: (810) 679-4400

FAX: (810) 679-4510

E-MAIL:

info@cotterman.com

Summary of Contents for CAL OSHA 6500 Series

Page 1: ...ICAL HAZARDS AND OBSTRUCTIONS STEP 1 INSTALL HANDRAILS DRAWING A NOTE DO NOT TIGHTEN ANY BOLTS UNTIL INSTRUCTED TO DO SO a PLACE THE LADDER STILE D ON THE FLOOR BE SURE TO ASSEMBLE ON A PROTECTIVE SUR...

Page 2: ...RE 3 FIGURE 1 FIGURE 2 DRAWING A STEP 3 FRAME ASSEMBLY DRAWING B a USING 2 3 8 16 x 1 1 4 HEX HEAD CAP SCREWS LOCKNUTS BOLT THE TOP OF THE BACK PANEL E TO THE OUTSIDES OF L1 b USING 2 3 8 16 x 1 1 4 H...

Page 3: ...OLTS DO NOT PROCEED UNTIL ALL BOLTS ARE SECURE AND THE LADDER IS STABLE DRAWING C TO TAKE YOUR 6500 SERIES LADDER DOWN FOR TRANSPORT OR STORAGE REVERSE STEPS 3 AND 4 THE LADDER MUST BE LAYED ON ITS SI...