DYNA-CUT
10
SETTING UP YOUR DYNA-CUT
INSTALLING A FLEXABLE DIE
1. Take the pressure off of the dies using the hydra jacks this
will make the cylinder easier to spin.
2. Rotate the cylinder so that the 3 threaded guide holes are
facing you.
3. Install the guild pins these will help line up the die.
4. Place die one evenly until the leading edge is flat against
the magnetic cylinder.
5. Remove the guild pins you may need to use an Allen tool in
order to remove.
6. Rotate the cylinder forward by hand this will pull the die
onto the magnetic cylinder once it is fully on the cylinder in
sure that the lines on the front and rear of the die line up
this will show if there is any skew on the die install.
REMOVING A FLEXABLE DIE
1. Take the pressure off of the dies using the hydra jacks this
will make the cylinder easier to spin.
2. Rotate the cylinder so that the seam of the die is facing you
3. Use the die removal tool. Slide it under one corner of the
die pull the die off of the magnetic cylinder. Carefully begin
to pull the die off of the cylinder. Note that the sides and
knife edges of the die are very sharp handle with care
always move slowly and make sure you have steady grip.
