PROGRAMMING FOR CREASING
•
•
•
•
Set-Up
: Pressing this will present a request for
the selection of a distance where the location of
the number is requested in hundredths of an inch
from the lead edge of the sheet.
•
•
•
•
Crease Test:
Pressing this button will fire the
crease bar one time.
SETTING UP CREASING
Crease Mode:
Press the PERF/CRS button twice this will put the machine in crease
mode then hit enter and follow the steps below.
EXAMPLE:
DISPLAY READS:
Dist 1 = 0.00
You can now enter the desired location for your crease, from .1 to 20 inches.
Dist 1 = 1.50
Sel Crease Bar = 0
You can now select the crease bar you have selected for the job.
Sel Crease Bar = 1
End Program? Y/N
Answering yes will complete the programming sequence. Answering no will prompt the
next location for a crease (see next page) the EZ CREASER will accept up to 10 locations
to crease.
6
