EXAMPLE:
DISPLAY READS:
Dist 2 = 0.00
Dist 2 = 5.00
Sel Crease Bar = 0
Sel Crease Bar = 1
End Program Y/N
Program Complete
You have now programmed your EZ CREASER to crease in two locations. Press run and
place 1 sheet on the feed table. The sheet should feed through stopping twice to crease.
If this does not occur, check your mode and make sure your selections have been
accepted. Remember, the speed and mode can be changed at any time, and will not
affect the program.
BATCH COUNTER
EXAMPLE:
DISPLAY READS:
Batch Count = 0
Batch Count = 250
EZ Creaser
This will allow 250 sheets to pass the sensor then stop transport automatically. Pressing
run will batch another group of 250 sheets. You can set the batch counter up to 9999.0
the feature is convenient for chip boarding small groups to be padded, or wrapping
larger jobs in predetermined packages.
CLEAR BATCH COUNT:
DISPLAY READS:
Batch Count = 250
Batch Count - 0
EZ Creaser
7
