SETTING UP YOUR EZ CREASER
STAND (
optional
)
1. Open top half of box and remove components.
2. Assemble stand.
3. Place machine on stand as shown below.
4. Unscrew feed rail guide shaft, slide shaft out.
Place feed rails on feed table and slide shaft
back in going through feed rail guide brackets.
5. Place delivery tray in front so tray hooks under steel dowels directly below the exit
shaft shaft. Locate the magnetic paper stops and position them on the tray.
6. Inspect the remaining parts and place them near the machine where they are easily
accessible.
7. Plug in your machine. NOTE: the EZ CREASER required only 115v so any standard
outlet will accommodate it. However, it is important that the line has a good ground.
Also make sure the circuit is not overloaded with other equipment.
(NOTE: 230v will be used for European models)
3
