TRANSPORT OPERATION
•
A document may be slowly advanced through the transport by
pushing and holding this button.
EXAMPLE:
The motor should advance transport at slow speed and stop
whenever finger is lifted.
•
Controls on-off function of motor.
EXAMPLE:
Machine will run at mode and speed previously selected. If no
mode has been selected, it will automatically run in perf mode
at low speed.
•
Machine will stop.
NOTE
: If the EZ CREASER is stopped while a sheet is under the sensor,
the display will flash “sensor blocked”
DATA PAD
•
•
•
•
Data Keys 0-9:
Allows entry of numeric data
required for distances and crease designation.
•
•
•
•
Enter/Yes:
Stores input information from data
keys and answers display prompted questions.
•
•
•
•
Clear/No:
Erases errors entered and prompts
for clearing total count. Answers “no” to display
prompted questions.
PROGRAMMING CONTROLS
(Mode Selection)
Speed Select:
Pushing this will select speed, low, medium or high and show
the speed selected on the display.
Mode Select:
PERF/CRS
Pushing this will Change the mode your machine
runs in. By Default and every time your machine is powered off the machine will
start in PERF mode. Press the PERF/CRS mode button twice to enter into Crease
Mode.
EXAMPLE:
DISPLAY READS:
CRS Mode Low Speed
CRS Mode Med Speed
CRS Mode High Speed
These may be pressed until the desired mode is selected, then: Pressing
will now run transport at selected mode.
5
