12
MICRO SKEW ADJUSTMENT
The micro skew adjustment will allow for the rear adjustment of the feed rails. It
adjusts both of the rear feed rails at the same time. This makes it easier to adjust for
and straighten the perf or score.
SETTING THE AUTOMATIC FEEDER
For efficient Auto-feeding, the setting of the caliper to the vacuum wheel is very
important.
Use a piece of the stock to be run as a “feeler gauge”. Place a
sheet under the feed wheels, turn the feed wheel adjustment screw
(Counterclockwise to raise, clockwise to lower)
so that the paper can slip freely under the wheels. The feed wheels should
be barely touching the stock. If during the feeding you begin to get
doubles, lower the feed wheels just enough to stop the double sheeting.
The paper between the friction plate and the auto feed wheel must move
freely and should not be gripped.
HEIGHT ADJUSTMENT CALIPER
The caliper setting is what ensures the feeding of one sheets and prevents the feeding
of double sheets. It is very important that this caliper is set correctly. To set the caliper
take one sheet of the stock you are running and slide it between the caliper and vacuum
wheel. Take a second sheet and slide it back and forth, in and out while lowering the
height adjustment until the second sheet cannot slide under the caliper. DO NOT
OVERTIGHTEN! It is very important that the sheet is not pinched in anyway.
Height Adjustment Knob
Caliper Disk Lock Knob
Lock Knob
Adjustment Knob
