TABLEMATIC-PLUS IL LUSTRATION
1.
TABLE/work base
10.
ON/OFF Switch
2.
Platen
11.
Vertical adjust pressure
3.
Numbering Head
12.
Horizontal adjust screw
4. Action Indicator
13.
Electrical Outlet For Numbering Head
5.
Ink Cartridge Holder
14.
Circuit Breaker
6.
Cross Bar
15.
Built-in Side Guides
7.
Head Block Bracket
16.
Magnetic Backstop
8.
Head Leveling Bracket
17.
Foot Pedal
9.
Knurled Knob 1/4" -
18.
Control Panel
20 Head Lock Down Knob
Place the TABLEMATIC Plus on a an uncluttered, sturdy desk, conveniently located near a
115V grounded outlet. Place the footswitch on the floor and plug the main power cord into the
nearby outlet. DO NOT USE UNGROUNDED EQUIPMENT ON THE SAME CIRCUIT.
..-------- LIMITED WARRANTY--------.
Count Machinery Company warrants it's equipment against defective parts or workmanship under normal use and
service for a period of: (1) year on all electrical and other parts; (90) days on numbering heads, During this time,
COUNT will either repair or replace any COUNT unit returned (shipping prepaid) which, after examination by us, is
determined to be defective. All freight charges for equipment sent in for warranty service is the responsibility of the
purchaser and must be prepaid. Count will not be held responsible for any shipping charges. You may request
your desired shipping method when the product is returned. If no me1hod is stated Count will send the time back
UPS Ground. This warranty will be voided, if the product has been repaired or altered by anyone except for Count,
or which has been subjected to misuse, negligence, or accident. Under no circumstances
will
Count be liable for
consequential damages. The user shall determine the suitabiltty of the product for the intended use and the user
1 ,
assumes all risk and liability whatsoever in connection herewith. For service. return the unit prepaid with written
\
I
explanation of service needed to:
COUNT MACHINERY COMPANY 2128 Vineyard Ave. Escondido, CA. 92029, 760-489-1400 Fax: 760-489-1543.
J
2
