Action Indicator/
Repeat Selector
Action Indicator
Shaft& C Clip
Wheel
Assembly
Ink Cartridge
Swing Arm
Action Indicator/
Repeat Selector -
S-AAM-0870
WheelAssembly
-H-1125
Ink Cartridge
Swing Arm
-S-UNS-0912
Action Indicator
Shaft &
C-Clip
-
H-1176
DEPRESSING A WHEEL
The standard Numbering Head is capable of recessing the first
three wheels so there is no image when striking. For example,
to print the number 4750 instead of 004750, you will need to
depress the first two wheels. To do so. remove the Numbering
Head from the Head Bracket and hold rt upside down resting ,t
on a flat surface.
Swing the Ink Cartridge away from the wheels (or remove).
Rotate the 1st wheel until the 9 is in the up position. Then
press forward slightly and down. you will feel the wheel depress
below the level of the others. Do the same to the 2nd wheel.
Now you can print a 4 digit number. To return to position, simply
rotate the wheel and 11 will pop up. This feature is also available
on the custom Numbering Wheel with letters. Rotate the wheel
until the blank position 1s up then press forward and down.
CHANGING DIRECTION
OF THE HEAD
The Numbering Head is capable of rotating 270 degrees in 90
degree increments. To change the direction, simply remove the
Vertical Bracket (using the 5/32 Wrench Supplted) and reinstall
on the desired side. NOTE: To get to the Upper Mounting Screw
for the Vertical Bracket,
you
must remove the Lock Knob and
Pressure Adjustment Screw first. Take notice of how far the
Adjustment Screw extends below the Stem so that when
replacing you have a reference point. When replacing the
Pressure Adjustment Screw, compress the sprrng slightly before trying to screw in the Adjustment Screw. This
is a very fine thread and can easily be started incorrectly leading to thread damage. Do not try to press the
Spring in with the AdJust Screw and turn at the same time.
(Trust Us1) See photo.
3
