Version
4.0
40
the door glass. Removal of these glass retaining clips can be accomplished with household tools. Order the
necessary replacement screws or glass clips when ordering glass to ensure worn parts are replaced.
GLASS-CERAMIC SPECIFICATIONS
Manufacturer
Euro Kera
Window Type
Glass-Ceramic, Kera Lite®
KERA LITE®
glass-ceramic has a thermal endurance far exceeding that of normal tempered glass.
KERA
LITE®
is designed to operate at temperatures ranging from -
400
0
F
to +1400
0
F
.
Despite its superior thermal
properties,
KERA LITE®
stove windows should be treated with care. This glass-ceramic can still be
scratched or broken by mechanical abuse. When cleaning the window, use only non-caustic, non-abrasive
cleaners. The Crossfire stove uses
KERA LITE®
glass-ceramic that is 0.197 inches thick +/- 0.008 inches.
Country Flame custom cuts each
KERA LITE®
glass at its factory to fit the Crossfire stove. If problems
occur with glass or any replacement part is needed, contact Country Flame or a local authorized dealer for
assistance in ordering the necessary parts.
CAUTION:
Do not attempt to clean hot glass. Do not abuse, strike, slam shut, or operate the
Crossfire stove with any broken glass in the appliance.
GASKET REPLACEMENT
Remove the doors from the unit. Place the doors, face down on a protective surface to ensure no marring or
scratching occurs during gasket replacement. To replace the Thermoglass
™
knitted rope and tape gasket, first
remove all of the old material and gasket cement. Use a putty knife or other sharp instrument to assist in
removal. Use caution to prevent injury when removing old material. It is important to ensure the doorframe
area is totally clean before installing the new gasket cement and material. The gasket must fit tight against the
door frame in order to ensure a proper airtight seal when the stove is being operated. Apply gasket cement to
the gasket channel per instructions provided with the gasket kit. Once the cement has been properly applied,
install the new gasket. Both gasket and gasket cement are available from your authorized Country Flame
dealer. The following table defines the gasket material used in the Crossfire stove:
Gasket
Length Quantity Dimensions
Around glass
4.25 feet each
1
¾” wide by 1/16” thick tape
Doorframe
5 feet each
1
3/8
” rope, high density
Ash drawer
37 inches
1
½” wide by 1/8” thick tape
CROSSFIRE CLEANING
A Crossfire stove will require general cleaning, depending on frequency of use. During heavy use, daily
cleaning of the firebox will be required and less frequently during light use. Allow the ash in the fire box to
completely cool before removing the waste with an industry approved ash vacuum.
The stove should be professionally cleaned twice a season if heavy use (daily use) is expected. A certified
chimney sweep will have the proper tools to make short work of semi-annual cleaning. Country Flame has
designed the Crossfire to make semi-annual cleaning as simple as possible. In fact, Country Flame designed
the Crossfire so that it does NOT require removal from the fireplace in order to be properly cleaned. The
following figures show how to access the cleaning ports on the Crossfire. By understanding how to
thoroughly clean your Crossfire, the operator can maintain the stove in tip-top shape to ensure proper
combustion and high efficiency. If questions do arise, do not hesitate to contact your Country Flame Dealer
for additional information.
