Country Heart 2000 L, Owner'S Operation And Instruction Manual

Ussc 15

OUTSIDE COMBUSTION AIR

Your wood stove is approved to be installed with an outside air intake which is necessary for a mobile 

home. This type of installation is also required in air tight houses and houses with negative pressure 

problems. You can purchase this option through your heater dealer. Make sure to specify the part 

number mentioned in this booklet. Installation instructions are supplied with the air intake kit.
Outside combustion air may be required if :
1. Your stove does not draw steadily, smoke rollout occurs, wood burns poorly, or back-drafts occur 

whether or not there is combustion present.

2. Existing fuel-fired equipment in the house, such as fireplaces or other heating appliances, smell, 

do not operate properly, suffer smoke roll-out when opened, or back-drafts occur whether or not 

there is combustion present.

3. Opening a window slightly on a calm (windless) day alleviates any of the above symptoms.
4. The house is equipped with a well-sealed vapor barrier and tight fitting windows and/or has any 

powered devices that exhaust house air.

5. There is excessive condensation on windows in the winter.
6. A ventilation system is installed in the house.

For use in MOBILE HOMES (U. S. installations ONLY):

•  

WARNING! DO NOT INSTALL IN SLEEPING ROOM.

•  

CAUTION! THE STRUCTURAL INTEGRITY OF THE MOBILE HOME FLOOR, WALL, AND 

CEILING/ROOF MUST BE MAINTAINED.

•   INSTALL IN ACCORDANCE WITH 24 CFR, PART 3280 (HUD).
•   USE  A  FACTORY  BUILT  CHIMNEY  THAT  COMPLIES  WITH  UL  103  STANDARDS;  

THEREFORE IT MUST BE A TYPE HT (2100°F).

•  USE A SPARK ARRESTER.
•   THE STOVE MUST BE ATTACHED TO THE STRUCTURE OF THE MOBILE HOME. USE 

THE FOUR(4) HOLES IN THE BOTTOM FLANGES OF THE HEATER’S PEDESTAL TO 

SECURE THE UNIT TO THE FLOOR. THEN INTALL/RE-INSTALL THE TRIM.

NONCOMBUSTIBLE FLOORING

Illustration: Securing heater to the Floor.