-4-
ASSEMBLY INSTRUCTIONS
Blower Assembly
THE BLOWER ASSEMBLY MUST BE DISCONNECTED
FROM THE SOURCE OF ELECTRICAL SUPPLY BEFORE
ATTEMPTING THE INSTALLATION.
THE BLOWER ASSEMBLY IS INTENDED FOR USE ONLY
WITH A STOVE THAT IS MARKED TO INDICATE SUCH
USE.
DO NOT ROUTE THE SUPPLY CORD NEAR OR ACROSS
HOT SURFACES!
Fix the assembly to the back of the stove with the four
screws provided.
Pedestal Trim Assembly
Attach to the pedestal base at the location shown
using the screws provided.
ASH PAN ASSEMBLY
If not already installed, slide the ash pan inside the ash pan
housing.
2 BOLTS PER LEG
LEG ASSEMBLY
If not already installed or for purpose of repair, follow these
directions. Because of this heaters weight, we suggest getting
assistance maneuvering it into position.
Begin by removing all the firebrick. Carefully roll the heater onto
its side, placing a couple wooden blocks to hold the heater off
the legs. A piece of carpet would also help reduce the chances of
scratching the unit. Once you’ve attached the legs with the sup-
plied hardware, stand the heater back on its legs.