ENG
LISH
11
PREPARATION FOR USE – LEAK TESTING
A leak test is used to determine the integrity of a seal. Before using your gas griddle, perform a leak test on the connection
between the regulator and the gas cylinder to reduce the risk of serious bodily injury or death from fire or explosion. A leak test
should be performed a minimum of once a season, as well as:
• before lighting your griddle for the first time,
• every time the gas cylinder has been changed,
• after travel, especially over rough or bumpy roads,
• after a prolonged period of storage or non-use.
HOW TO PERFORM A LEAK TEST
Supplies Required:
1 x Bowl (
empty, clean)
1 x Paint Brush (
clean)
Dish Washing Liquid
Water
Procedure:
1. Position the griddle in a well-ventilated area. Ensure the
griddle is cool to the touch, and not in use. Verify that the
regulator value is turned to the OFF position and that the
gas cylinder is tightened securely to the regulator.
IMPORTANT: Ensure there is no open flame or
smokers nearby.
2. Mix a solution of one part of water with one part of dish
washing liquid in a bowl. The solution will make bubble, as
it will be concentrated.
3. Use a paint brush to apply the solution onto the seal
arease between the regulator and the gas cylinder. Note
“X” areas in illustration. Visually inspect for streams of
bubbles coming from a defect or break in the seal.
NOTE: If a leak appears, repeat gas cylinder installation procedure, but do not over-tighten. Hand-tighten
only. Repeat leak test after re-installation to ensure seal is secure.
IMPORTANT: Do not use the gas griddle if you detect a gas leak that cannot be corrected by using the leak
test procedure. Contact your local Fire Department or Customer Care for alternative measures of testing
to ensure proper precaution.
20 lb
9 kg
X
X
X
X
X
OFF
APAGADO
Watch for bubbles
