ENG
LISH
9
CONNECTING TO A GAS SUPPLY
GAS CYLINDER REQUIREMENTS
The griddle is set and tested with liquid propane (LP) gas only. The regulator supplied is set for 27.94 cm (11 inch) water column
(WC) and is for use with LP gas only. The factory-supplied regulator and hose must be used with a 9 kg (20 lbs) LP gas tank.
Contact your gas supplier for a special regulator for bulk gas that fuels other appliances.
CAUTION: It is important to inspect the full length of the gas line hose. If it is evident there is excessive
abrasion or wear, or the hose is cut, the hose must be replaced prior to the appliance being used.
INSTALLING A GAS CYLINDER
1. On the right side of the cart, place a 9 kg (20 lbs) gas tank near
the regulator. Make sure the gas tank valve is in OFF position.
Ensure the gas tank is completely upright and level on a solid
surface, as it is unsafe to operate the griddle if the gas tank is
not installed properly.
2. Ensure the regulator valve on the griddle is completely closed
by turning the knob clockwise to the OFF position.
3. Remove the protective caps from the regulator valve opening
and the top of the gas cylinder. Save the caps.
4. Insert the gas cylinder valve into the threaded opening of the
regulator valve. Turn the cylinder clockwise until firm. Hand-
tighten only.
5. Gas cylinder is now installed.
The outdoor unit, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes
with the National Electrical Code ANSI/NFPA 70, or Canadian Electrical Code, CSA C22.1.
1. Do not store a spare LP gas tank under or near this appliance.
2. Never fill the tank beyond 80 percent full.
3. If the information in 1) and 2) is not followed exactly a fire causing death or serious injury may occur.
4. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder
valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane.
DISCONNECTING A GAS CYLINDER
1. Ensure the regulator valve on the griddle is completely closed by turning the knob clockwise to the OFF position.
2. Turn the cylinder counter-clockwise (by hand) to disconnect from the regulator valve opening. Replace the protective caps
on the regulator valve opening and the top of the gas tank for storage (if not empty).
NOTE: If storing the griddle indoors, leave the gas cylinder outdoors.
WARNING: Do not fold up or transport griddle with gas cylinder attached. The cylinder may loosen off the
valve and cause a gas leak, possibly resulting in an explosion, fire, or severe bodily harm. Disconnect gas
cylinder first before travel or storage.
Flip and put the BBQ into standing position as shown below.
Hang the oil drum 8) onto the oil drum hook as shown.
Secure the legs by tightening the pre-installed wing nut.
To attach the regulator to the gas cylinder, it is tightened in an anti-clokcwise
direction.
Read “Setting up the Barbecue” before using your barbecue
20 lb
9 kg
X
X
X
X
X
OFF
APAGADO
