CountyLine CL1800DC, Owner'S Manual

Tables 

10

LED Operating Code Display

System Operating Condition

Charging

Battery status

Pump status

AC power

Silenced audible alarm

System Alert

Indicates       115V AC Power is connected

NOTE: All of the situations listed above indicate normal system operation; no action is required.

However, if the BBU pump is running or has run, check the primary pump and actively monitor the 

charger status for battery life. Always reset the charger after the pump runs.

During normal system operation, the ‘System Alert’ LED does not light up. The “AC Power” LED

is lighted as long as the system is plugged in to an operating AC power circuit. 

Indicates       Pump is running (continuous LED)

Indicates       Audible alarm is switched off

Indicates       Battery is charging normally

Indicates       Continuous LED: battery charge is above 20%,
  

        system is maintaining charge 

Indicates      Slow flashing LED: battery charge is below 20%

5765 0108

LED is Flashing (Slow)

=

LED is OFF

LED is ON Continuously

=

=

LED is Flashing (Fast)

=

Indicates       Fast flashing LED: Pump has run

Indicates       Fast flashing LED: Battery pre-qualification test is running

TABLE II – Operating Code Displays (LEDs Lighted Continuously or Flashing)

Control LED:

Continuous Illumination Indicates Normal Operation:

AC Power

AC power is present.

Pump Status

The float switch has been activated. The LED remains on (flashing) after the pump has stopped. Depress the‘System Test’ button to reset 
it.

Silenced Audible Alarm

Audible Alarm has been silenced. Press and release the ‘Silence Alarm’ button to reset (activate) the audible alarm and turn OFF the 
LED.

Charging

Indicates that the battery is charging – see Table II, above.

Battery Status

A.  Continuous ‘ON” - the battery voltage is above 10.9 Volts DC and capacity is above 20%.
B.  Slow Beep/Slow LED Flash - the battery’s capacity is below 20%, and voltage is between 8.2VDC and 10.9VDC.
C.  Fast Beep/Fast LED Flash - the battery has been discharged to less than 8.2VDC.

System Alert

Flashing (in unison with the buzzer) indicates that the charger has entered ‘Failure Mode’. Press the ‘System Test’ and ‘Silence Alarm’ 
buttons to reset it. 

NOTICE If the source of the failure is not corrected, the charger will reenter ‘Failure Mode’. See Table III for error code information.

TABLE III – LED Function Displays (LEDs Lighted Continuously)