ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
TGS20CW
PAGE 1 OF 2
V-3
COURTYARD CREATIONS INC.
!
!
!
!
FIGURE 1
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #7)
- Hex. Key Wrench (See Part #8)
Step 1:
Place the table top (#1) onto a non-abrasive
surface, such as carpet, with its underside facing
upwards. Insert the legs (#2) into the plastic holders
on the underside of the table top (#1) rim. Fasten
them together by using screws (#4). See Figure 1.
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely
assembled.
Do not sit or stand on this table.
Do not discard of any of the packaging until you have checked that you have all the parts and pack
of fittings.
Keep children away during assembly. This item contains small parts which can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain the assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
!
!
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
PARTS LIST
PART
NO.
MATERIAL CODE
PART
Q’TY
PART
NO.
MATERIAL CODE
PART
Q’TY
1
1
2
3
5
4
6
7
8
4
4
1
1
4
1
TGS20CW-CS05-1
TGS20CW-CS04-1
17C40A0708001YX
17C17A0403001YX
17KAA0101----Y4
TABLE TOP
LEG
CENTER CONNECTOR
SCREW ST4.2*12
BOLT M6*20
HEX. KEY WRENCH 4MM
HEX. KEY WRENCH 10MM
62TMS20SKY101
17KAC3101----Y3
STOP DO NOT RETURN TO STORE!
1
2
2
2
2
4
4
17FC05020601-YX
WASHER d6.5*D10*1.6
