30
INSTALLATION
INSTALLATION MANUAL
Ground anchoring assembly
(optional)
1)
Attach the L bracket on the post bracket with
included 1/4-20 x 3/4 in. carriage bolts and 1/4-
20 nylon hex lock nuts. (Figure 62) Repeat for all
four post brackets.
Note:
Depending on the space between the hot
tub and the posts, the location chosen for the
cover and the supporting surface construction,
the L brackets can be fastened on any side of the
post bracket. See Figure 61 to see all four
possible configurations.
WARNING
Do not overtighten any hardware. Failure to
follow this instruction may damage the paint or
the hardware itself.
2)
Carefully lay the post assembly on the ground on
a clean surface that is free of any debris, then
remove the two 1/4-20x1/2in. Phillips screws.
(Figure 63)
Note:
do not discard this screws.
WARNING
The post assemblies are heavy. Two people
might be needed to perform this.
Be careful while handling the post assemblies.
They are heavy and damage or injury may
occur if they are dropped.
Top view
Bottom
view
Post bracket
L bracket
1/4-20 x 3/4 in.
carriage bolts
1/4-20 nylon
hex lock nut
Square holes
Figure 61
Figure 62
1/4-20 x 1/2 in.
Phillips screws
Figure 63
Summary of Contents for C-HOR
Page 1: ...Revision 13 2018 04 23...
Page 53: ...INSTALLATION MANUAL APPENDIX 53 APPENDIX...
Page 54: ...54 APPENDIX INSTALLATION MANUAL Wiring diagram North America 60 Hz 120 VAC Operator...
Page 55: ...INSTALLATION MANUAL APPENDIX 55 Wiring diagram Europe 50 Hz 220 VAC Operator...
