INSTALLATION MANUAL
INSTALLATION
43
Seal application
1) Once the Covana cover has been fully
assembled, raise the cover and remove the
foam spacers and tape. Lower the cover and
walk around the entire perimeter of the hot tub,
observing where the inside surface of the cover
will make contact with the hot tub. This will
determine the best location to apply the seal.
2) Dry the hot tub edge and the underside of the
cover with a clean cloth. Wait until it is dry.
CAUTION
Remove all dirt, oil and moisture for a proper seal
adhesion. The use of mild detergent can clean
the surface.
Refer to the hot tub manufacturer’s
recommandations.
3)
Apply the provided masking tape around the hot
tub where the seal will be installed. The masking
tape will ensure the seal is straight when pulled
corner to corner. The ideal location for the seal is
closer to the hot tub
’s interior edge, but on a flat
surface (Figure 102). The minimum turn radius
for the seal is 4 in (10 cm).
WARNING
The use of masking tape is recommended since
it will protect the acrylic tub from the clips’ glue.
Furthermore, pulling the masking tape from one
corner to the next will ensure straightness.
4) Apply the provided seal clips parallel on the
masking tape around the hot tub and ensure to
put more in the corners and on any tight turns,
filters, etc., keeping in mind that a limited
number of clips are provided. (Figure 102)
5) Start installing the seal joint at the opposite side
from the entrance of the hot tub (halfway in a clip),
with the adhesive layer facing up toward the
cover. (Figure 103 and 104)
CAUTION
•
Do not install the seal joint near a control
system or the critical components of the spa.
6) When the seal is installed around the entire hot
tub, you must cut the extra length as straight as
possible for the best joint finishing results.
Masking tape
Clip
Figure 102
Seal
Seal
connector
Figure 103
Seal
Figure 104
Summary of Contents for C-HOR
Page 1: ...Revision 13 2018 04 23...
Page 53: ...INSTALLATION MANUAL APPENDIX 53 APPENDIX...
Page 54: ...54 APPENDIX INSTALLATION MANUAL Wiring diagram North America 60 Hz 120 VAC Operator...
Page 55: ...INSTALLATION MANUAL APPENDIX 55 Wiring diagram Europe 50 Hz 220 VAC Operator...
