page-
36
OASIS COVER
8. Use the supplied alcohol swab and rub it on
the surface of the outer sleeve positioned on
the opposite corner of the light button to clean
the surface see
and
. Wait
two minutes for the alcohol to dry.
9. Apply the primer on the inside corner of the
indicated areas. Refer to
and
. The wire guard can also be held in place
and taped off around its perimeter to mark off
the application area.
IMPORTANT NOTE
Failure to apply the primer will result in the wire
guard unsticking over a short period of time. The
primer will act as the optimal bonding agent for the
paint. To use the primer, snap the bottle in the
middle for the liquid to come out see
.
WARNING
The bottle of primer (3M Primer 94) is considered
flammable, a serious irritant for the eyes, a skin
sensitizer,
an
inhalation
hazard,
toxic
for
reproductivity, carcinogenic and toxic for internal
organs. Please be careful when handling the
primer. Ensure proper ventilation prior to and during
the use.
FIGURE 54: PRIMER 94
10. Let the primer dry for at least five minutes at
temperature above 40°F (5°C). This will
ensure an adequate bonding surface.
FIGURE 55: AREAS TO CLEAN
FIGURE 56: AREAS TO CLEAN AND TO APPLY THE
PRIMER 94 (TOP VIEW)
11. Peel off a short length of the red plastic film
on the double-sided tape, fold the film toward
the outside. (Do this step for both sides) see
241146
OWNER'S MANUAL
REVISION 1
Summary of Contents for OASIS COVER
