5
3.4.
Connection of communication options.
The UPS has two communication ports:
USB
Intelligent Slot (SNMP)
To enable automatic management and monitoring of the UPS, connect the USB cable supplied with
the UPS, on one side to the USB socket on the UPS and on the other side to the USB socket on the
computer. The software provided with the UPS allows you to automate the processes of turning on /
off the receivers connected to the UPS depending on the events that occur on the UPS (e.g. power
failure, low battery level, overload, etc.). The software also allows for ongoing monitoring and logging
of UPS event history.
The UPS also has a slot for additional cards, which enables retrofitting with an SNMP network card for
remote communication via the network.
3.5.
Power connection - configuration 3:3
NOTE: UPS operation configuration may only be changed by an authorized service!
Fig. 2 Terminal for connecting the power supply for COVER JR 10 - 20K configuration 3: 3 phase
3.6.
Power connection - configuration 3:1
NOTE: UPS operation configuration may only be changed by an authorized service!
Fig. 3 Power supply terminal for COVER JR 10 - 20K configuration 3: 1 phase