COVER serii NHS – User Manual
COMEX S.A.
5
2. Installation procedure
This chapter is devoted to the method of installation, method of laying and wiring of the UPS.
2.1. Introduction
The chapter presents the basic requirements for the location and wiring of the power supply. The
description presents a step by step installation instruction, which is a series of guidelines for the service
to be followed during assembly.
警告
危 险
Warning - Installation may only be carried out by an authorized service center
1. Do not connect electrical devices to the power supply before finding a service technician that the
power supply is properly connected and configured.
2. The UPS should be installed by qualified technical personnel in accordance with the guidelines
contained in this chapter.
警告
危 险
Warning: dangerous batteries
Special precautions must be observed when working with batteries connected to the power supply.
After connecting the battery, the voltage on the terminals exceeds 400Vdc and is potentially fatal.
To protect your eyes against accidental arcing, it is recommended to use safety goggles.
Additionally, it is recommended to:
Remove rings, watches and all metal objects.
Use only tools with insulated handles.
Wear rubber gloves.
If the battery leaks or the battery is damaged in any other way, it must be replaced. Damaged
batteries should be stored in a container resistant to sulfuric acid and disposed of in accordance
with local regulations.
If the electrolyte comes into contact with the skin, immediately contaminate the area with water.
2.2. Initial check
Perform the following checks before installing:
Check visually that the supplied devices, i.e. the UPS and batteries, have not been damaged as a
result of their transport. Damages should be reported immediately to the supplier.
Verify compliance of the delivered equipment with the installation requirements. The power of the
PSU is described on the label each time.
2.3. Location
2.3.1. UPS room
Zasilacz UPS jest przeznaczony do
instalacji wewnątrz budynku. Urządzenie powinno znajdować się w
czystym środowisku o odpowiedniej wentylacji, aby utrzymać temperaturę otoczenia w wymaganym
specyfikacją zakresie. UPS zapewnia wymuszone chłodzenie konwekcyjne przez wewnętrzne
wentylatory. Zimne powietrze
dostaje się do urządzenia poprzez otwory wentylacyjne umieszczone w
przedniej części obudowy i wydmuchiwane jest przez grille znajdujące się w tylnej części obudowy. Nie
należy blokować otworów wentylacyjnych.
Uwaga: UPS
powinien być zainstalowany na stabilnym i niepalnym podłożu.
