If your vehicle has an outside radio antenna which will not retract flush with the vehicle body, you will have to provide an opening in the cover.
We have included a non-corrosive plastic grommet set with your cover.
• Place the cover on the vehicle except for the fender or body panel where the antenna is located.
• Center the cover, align both seams with the roof edges and be sure the cover is pulled down evenly over the front and rear bumpers.
• Carefully unfold the portion of the cover that is next to the antenna and position it next to the base of the antenna.
• Recheck the overall positioning of the cover to make sure it has not moved.
• Make sure the cover lies flat over the hood and roof areas of the vehicle and mark the cover with the location of the antenna base and make a
hole with a sharp pencil.
• Using sharp scissors, make the hole opening 3/4” in diameter and install grommet. The outside grommet ring fit is very tight.
• Place the cover on a clean, hard surface. Position the inside grommet through the opening you made and then secure the outside grommet snap-
ring in place using a rubber mallet.
• Remove the antenna.
• Install cover on the vehicle.
• Check cover is aligned correctly.
• Using a sharp pencil punch a hole through the fabric at the antenna location.
• Using sharp scissors, make the hole opening 3/4” in diameter and install grommet. The outside
grommet ring fit is very tight.
• Place the cover on a clean, hard surface. Position the inside grommet through the opening you
made and then secure the outside grommet snap-ring in place using a rubber mallet.
• Lay cover over vehicle with the
front facing you. The front will be
marked with either an ID or logo.
(ID may be located on the inside
front of the cover)
• Make sure if using a grommet that
the antenna is placed through the
cover before proceeding.
• Stretch cover over the front and
rear bumpers.
• Place mirror pockets over mirrors.
• Release both ends of the cover from under the bumpers.
• Fold up both sides onto the top of the vehicle into a long pile approximately 2 feet(60cm) wide.
• Start at the front of the vehicle & fold the cover in 3 foot(1 meter) folds from the front to the back
If you encounter any problems during the installation of your Car Cover, please contact our Customer Service Department, Monday-Friday, 8AM-5PM(CST)
at
800-4-COVERS (800-426-8377)
or by e-mail at
sales@covercraft.com
.
You may also access help videos on the web at
covercraft.com
Scan code on phone or tablet to view full detailed car cover installation video:
Car Cover Installation
Grommet Installation
Car Cover Installation
Car Cover Removal
Non-Removable Antenna
Removable Antenna
TIPS
• To extend the life of your cover place vinyl tape over any areas exposed to severe abrasion.
• If installing cover after driving be careful not to let the cover come in contact with hot exhaust pipe.
• A tie-down rope is included and can be used to tighten the bottom of the cover through the loops sewn
under the driver and passenger side doors.
