Installing Back and Front Doors
Note: When installing Back and Front Doors, ensure that pre-installed straps are not pulled out of Hem.
1. Position a Door Panel (23) at desired end of Frame. The zipper faces the outside of
Portable Garage, the warning tag faces inside. Make sure zipper is closed while installing.
2. Locate the webbed strap that runs through perimeter of Door. The webbing is exposed at the peak,
shoulders and feet of the Door. Tie the loose ends of the webbed strap to the two Corner Legs.
3. Use a rubber mallet to disconnect Ridge Tube (4) from 3-Way Ridge Connector (11), and
place gap at top center of Door Panel around the Ridge Connector, as shown.
4. Wrap the Door Panel flaps around Rafter Tubes and Leg Tubes as shown and then
rejoin the tubes. Make sure strap is positioned inside frame.
DO NOT ATTEMPT
TO INSERT ANY FRAMEWORK TUBING INTO THE HEM ON FLAPS
.
Hem on
flaps
Place strap and flaps
inside of frame.
3
11
4
4
4-1
4-1
9
8
11
Inside of
Door Panel
Strap
Strap
Figure M: Door Panel Installation
5. Repeat step #3 for the 3-Way Side Connectors (8, 9) and Shoulder Tubes (4-1).
6. Assemble a Ratchet Tie Down (24) to each Strap end (see
Using Ratchet Tie-Downs
). Hook the assembled
Ratchet to the hole in Bent Corner Legs (6) and tighten ratchet until Door Panel is reasonably tight.
• Be sure flaps are folded over the tubes at the end and inside of the frame.
• Be sure the overlap of the door flap remains square over the end frame and reaches the ground at the base.
Strap
24
Figure N: Securing Door Panel
7. Repeat above process to install other Door Panel to opposite end of frame.
NOTE:
DO NOT OVERTIGHTEN RATCHETS.
Page 10
For technical questions, please call 1-888-866-5797.
Item 58741
