by pressing button
one.
5.During play back, Press Button two and it will
play the next file.
6. Press and hold Button two for
2 seconds. The
camera will return to the video file list.
7. In the video file list interface, press Button
two for 2 seconds, the camera will return to
standby mode.
8. Then press and hold Button one for
approximately 3 seconds, and the camera will
turn off.
Charging:
1. Connect the camera to your PC/labtop/USB
charger by using the USB cable provided.
2. Once connected, the red indicator on the
camera will turn on then flash. The unit will then
be charging. (You can also record while you
charge your camera if you set AutoRecord=Y.
(See below for directions.)
3. After around 3-4 hours when it stops flashing,
the camera is fully charged.
4. Remove the camera from the power source.
Attention:
1. 5 minutes after fully charged, the camera will