6 SIP Trunk Configuration
6.1.1
SIP Trunking Configuration
SIP Trunking configuration is performed using the UC320 Configuration Utility. You can enter the main parameters for
your Service Provider account on a "
Generic SIP Provider
". For further detail configurations of the UC320 refer the
UC3200 Admin Guide
will provide guidance about SIP Trunks deployments and associated parameters. Figure
below shows an example of the UC320 Configuration Utility SIP Trunk Configuration Screen.
The following are the configuration parameters needed for SIP Trunking as illustrated in Figure 6-1 below:
1. Provider:
Generic SIP Provider
2. Description:
Cox Communications SIP Trunking
3. Proxy:
192.168.1.1
(Enter the LAN IP Address of the Cox E-SBC. Note your actual LAN IP may be different! Please
refer to the network diagram in Figure 2 and IP Address worksheet in Table 1.)
4. Registration:
Checked
(Client-server SIP trunk, registration required)
5. Outbound
Proxy:
<blank>
6. Call
Capacity:
<Enter the actual quantity of purchased SIP Trunk concurrent call sessions>
7. Prefix dialed numbers with "1":
<blank>
(uses National Numbering plan)
8. Company
Name:
<Your company name>
(This will appear as the Display Name field on SIP messaging)
9. Account ID:
<As provided by Cox Communications>
10. SIP Domain Name:
<blank>
Note: The Cox E-SBC will automatically insert the “coxbusiness.com” domain name in all
outgoing SIP messages. Any value input here will be ignored by Cox.
Figure 6-1 SIP Trunking Configuration Parameters: 1 of 2
Property of Cox Communications, Inc.
Version 1.0
Page
10 of 13
