10
POWeR
once. The device should turn off. If it
does not, repeat steps 2–3, trying each code for
your brand until you find one that works. If it
still does not work, try searching for the code
(see
Searching For Your Code
on page 12).
NOTE: If the device does not have a
POWER
key, press the (
Play
) key.
5.
Repeat steps 1–4 for each device you want the
the remote control to control. For future refer-
ence, write down each working device code in
the following boxes:
aUX
aUX Device
____________________
VCR
TV
Cable
PROGRaMMInG TV/VCR COMbO COnTROl
If you own a TV/VCR Combo, perform the following
instructions to control this device:
1.
Turn on your TV/VCR Combo and insert a
video cassette.
2.
On the remote control, press
DVD
once.
Press and hold
seTUP
until the
DVD
key
blinks twice, then release
seTUP
.
3.
Use the setup codes for TV/VCR combos
on
page-56 to locate the brand name and then
enter the first four-digit code for your TV/VCR
Combo. If you perform this procedure correctly,
the
DVD
key will blink twice.
NOTE: If the
DVD
key did not blink twice
after entering the code’s last digit, then repeat
steps 2 through 3 and try entering the same
code again.
4.
Aim the remote control at your TV/VCR
M7820BP1.indd 10
3/13/2007 3:54:00 PM
