14
Then press and hold
seTUP
until the
Cable
key blinks twice, then release
seTUP
.
3.
Enter
9 - 8 - 2
. The
Cable
key will blink
four times.
4.
Perform the instructions in
Programming
Device Control
on page 9 to program device
control for the desired cable converter and
interactive service. Upon completion, perform
the remaining steps (5 and 6 on this page) to
again lock the ID lock.
5.
On the remote control, press
Cable
once.
Then press and hold
seTUP
until the
Cable
key blinks twice, then release
seTUP
.
6.
Enter
9 - 8 - 2
. The
Cable
key will blink
twice.
PROGRaMMInG Channel
COnTROl lOCK
By default, the remote control’s channel-control capabilities
are locked to the cable converter. The affected keys are
0~9
,
Ch+
,
Ch–
,
enTeR
, and
lasT
. This will guarantee that you
do not inadvertently change a channel on your TV or VCR.
However, you can de-activate this feature to allow full access
to these keys in the TV and VCR modes.
To De-activate Channel Control lock:
1.
On the remote control, press
Cable
once.
Then press and hold
seTUP
until the
Cable
key blinks twice, then release
seTUP
.
2.
Enter
9 - 7 - 3
. The
Cable
key will blink twice.
3.
Press
Ch–
once. The
Cable
key will blink
four times.
4.
Now, the remote control will provide TV and
VCR channel-control capabilities while in TV
or VCR mode.
NOTE: This feature does not affect the
AUX
mode.
M7820BP1.indd 14
3/13/2007 3:54:00 PM