20
Using the Ignition System:
1.
Open the canopy
2.
Keep your body, arms and face
as far away from the burners
and cooking surface as possible
3.
Depress and rotate the knob counter clockwise to the "High" position.
a.
As you are nearing the "High" position, you will notice the valve getting tougher to turn. This is the
spring inside the valve building up energy to create the spark. Once you hear a click, the igniter has
fired the spark and you must turn the valve completely off to generate another spark.
b.
Do not turn the knob too fast, as you need the gas to travel into your manifold, then to your valve
and finally into the burner where it will meet the spark from the igniter (at the front of the burner).
Alternatively, if you turn it too slow, you can cause a build up of gas in the grill and create a large
flash when it ignites.
4.
If the burner does not catch on the first attempt, try again immediately but be very aware of any gas
building up inside the grill. If the grill does light after three consecutive attempts, turn the valves to the
"Off" position and allow the grill to clear of any built up gas for 5 minutes.
5.
If at this point the grill will still not ignite, you can try the manual lighting process below with a long stem
lighter and you can also contact Coyote Customer Service for further assistance to troubleshoot your grill.
6.
To turn the grill "Off," you simply turn each knob clockwise until it can not turn anymore. It is also normal to
experience a popping noise when the burners are turned off abruptly.
Manually Lighting the Burners:
•
If for some reason, igniters fail to light, burners can be lit with a gas lighter.
o
To light gas grill with a gas lighter
, make sure the grill has been leak tested and burners can
be properly located. Remove the cooking grids and flavorizers from the burner you wish to
light. Insert long-necked gas lighter, placing it near the burner ports. Press in the far right
control knob and rotate left to “HIGH” setting to release gas. Turn on the button on gas lighter,
burner should light immediately. Place back the cooking grids and flavorizers. Adjust burners
to desired cooking temperature.
Lighting Instructions for:
C1C34 – C1C36 – C1S36 – C1SL36 – C1SL42
Summary of Contents for C1C34
Page 32: ...30 C1C34 Exploded Parts View ...
Page 34: ...32 C1C36 Exploded Parts View ...
