8
13. REINSTALL THE FILTERS
CAUTION
Remove the protective plastic film covering the filters before installing them.
It is recommended to install side filters first and to finish with center one(s).
1. Insert the end of the filter with the spring into the front channel of the hood.
2. Raise the other end toward the inside of the hood and insert in the grease drip rail.
14. OPERATION
BLOWER
The blower is operated using two controls.
Use the ON/OFF rocker switch (
1
) to start and stop the blower. When turned ON,
the switch turns red and the blower operates at the speed set by the speed control
knob (
2
).
Turn the speed control knob counterclockwise to increase blower speed – clockwise
to decrease speed.
COOKTOP LIGHTING (HALOGEN)
Use the ON/OFF rocker switch (
3
) to turn the halogen lights ON or OFF.
1
2
3
HC0087
1) ON/OFF blower switch
2) Blower speed control knob
3) Halogen light switch
HEAT SENTRY™
This hood is equipped with a Heat Sentry™ thermostat. This thermostat is a device that will turn on the blower to high speed if it senses
excessive heat above the cooking surface.
1) If blower is OFF - it turns blower ON to high speed.
2) If blower is already ON - it sets blower on high speed.
When the temperature drops to normal, the blower will return to its original setting.
WARNING
!
The HEAT SENTRY can start the blower during a range top fire or other excessive heat situations even if the hood
is turned off. In this case, it is impossible to turn the blower OFF using control panel switch. To stop the blower,
disconnect blower cord plug.
HD1078
CAUTION
Before using the range hood, remove the remaining protective plastic film covering the hood surfaces.