Using your Hot Water Bottle
1. Remove the
Stopper
and place to one side.
2.
NEVER
use boiling water to fill your bottle.
3.
DO NOT
fill using water from your domestic hot water system this can significantly
shorten the life of your bottle.
4. Hot water Bottles are intended for partial filling only. Fill your Bottle to no more than
2/3 capacity or less
.
5.
DO NOT
overfill as this may cause the bottle to burst.
6. When filling, hold the
Bottle
firmly around the neck in an upright position and fill
SLOWLY
to avoid hot water splashing back.
RISK OF SCALDING
.
7. When approximately 2/3 full or less expel air from the
Bottle
by carefully lowering
it onto a flat surface until water appears at the opening. Then, without moving the
Bottle
, replace the
Stopper
and tighten.
8. Tighten sufficiently to prevent leakage, normally, finger tight is sufficient.
9. Now hold the
Bottle
upside down to check for leaks and remove any water from the
funnel by gently shaking.
10. We recommend that when filled with hot water you always use the provided
Cover
to
prevent the possibility of contact burns. See below for fitting guidance:
a. Fold the
Bottle
in half along its length.
b. Push the folded end down into the
Cover
through the elasticated opening
(see images below):
c. Make sure the
Cover
is correctly fitted with the funnel located in the end of
the
Cover.
