CF353C-H, CF354C-H, CF503C-H, CF504C-H, CF653C-H, CF654C-H
STANDING PILOT
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A. This appliance has a pilot, which must be lighted by
hand. When lighting the pilot, follow these instruc-
tions exactly.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone
in your building.
•
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don’t try to repair it, call a qualified
service technician. Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
PN 91217 02/05
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
Page 10
1.
STOP! Read the information on the safety label.
2.
Set thermostat to lowest setting.
3.
Turn off all electric power to the appliance.
4.
Remove lower front panel.
5.
Push in gas control knob slightly and and turn
clockwise to “OFF”.
6.
Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP! Follow “B” in the information on the safety
label. If you don’t smell gas, go to the next step.
7.
Locate red piezo ignitor button. Locate pilot. (Follow
metal pilot tube from gas control).
8.
Turn gas control knob counterclockwise to
“PILOT”.
9.
Push in pilot control knob and hold in. Immediately
begin a series of pushing and releasing the red piezo
ignitor button, while observing the pilot. Continue to
spark until pilot is lit. Continue to hold the pilot control
knob in for about one (1) minute after the pilot is lit.
Release the pilot control knob and it will pop back up.
Pilot should remain lit. If pilot goes out, repeat steps 5
thru 9.
•
If knob does not pop up when released, STOP and
immediately call your service technician or gas supplier.
•
If the pilot will not stay lit after several tries, turn the
gas control knob to “OFF” and call your service
technician or gas supplier.
10. Turn gas control knob counterclockwise to “ON”.
11. Replace lower front panel.
12. Turn on all electric to the appliance.
13. Set thermostat to desired setting.
PN 91217 02/05
1.
Turn thermostat to lowest setting.
2.
Turn off all electric power to the appliance if service is
to be performed.
3.
Remove lower front panel.
4.
Push in gas control knob slightly and turn clockwise
to “OFF”. Do not force.
5.
Replace lower front panel.
PN 91217 02/05
Pilot Control Knob
NOTE: Knob
can not be
turned from
“PILOT” to
“OFF” unless
knob is pushed
in slightly.
Do not force.
Gas Control Knob
