2.16 Guidance of Disassemble the zero gravity actuator
A
:
Take off the footrest first(Refer to
Guidance of Disassemble the footrest assembly )and the
front cover.
Take off the backrest Rear cover(Refer to
Guidance of Disassemble the
Rear cover of backrest)
B: Locate the zero gravity actuator.Use the diagonal cutter get ride of the cable ties which fasten actuator
wires to the frame.Then tack the zero gravity actuator wire harness to locate the wire connector.Then
disconnect them.
C:
Remove the cotter pin and take off the bolts at front of zero gravity actuator.Locate the four screws on
both side of the rear of zero gravity actuator. Use the screwdriver to take off these four screws and pull out
the fixing iron.Then we can detach the zero gravity actuator.