9
04
Chair Installation & Moving
A
A
B
B
Note:
Ensure sufficient spaces around the chair. When backrest reclining and footrest
raising, the minimum 80cm space must be ensured both at the front and the back of chair.
Bottom of the chair may damage the tatami mattress or floor. It is recommended to spread
a piece of mattress under the chair.
Step 1:
● Use the diagonal pliers to cut off the cable tie which binds the stopper of the backrest,
and unwrap the packaging material of the backrest actuator
(a)
underneath the seat pad
and both seat anchor
(b)
.
● Put the backrest pad onto the seat pad which was used to avoid the backrest pad from
oil pollution from seat anchor on both side.
● Lift the backrest, and insert part A into part B as shown in picture.
Note:
Put remote controller wire out of the side panel which could avoid of wire damage
when install the backrest.
at lease 80cm
at lease 80cm
(a)
(b)
Summary of Contents for EC-618B
Page 1: ...INSTRUCTION MANUAL EC 618B...
Page 32: ......
