STEP 14:
The backpad is attached to the backrest with VELCRO®. Make sure that it is properly
aligned and taught.Then zip the backrest pad onto the backrest.
STEP 15:
Adjust the shoulder airbag by rotating them into position.
Zipper the back pad into the backrest.
STEP 13:
Secure the side board with screw nut and washers. Then attach the side board cover.
STEP 12:
Screw the four double-threaded screws onto the frame.
Take the side board close to the base and connect the air hose and wire connecters.
Attach the side boards onto the base. Make sure the four double-threaded screws go
through the screw holes on side board. As pictured below.
Screw the four double-threaded
screws onto the frame.
Make sure the four double-threaded screws
go through the screw.
Connect the air hose and wire connecters.
Holes on side board.
Locute four screw holes on the frame.
