Use and Care Manual
10/11
Press the optional 1 to 3 hour timer button to start smart wake-up mode.
When time is up, the On/Off button will flash, soft air massage will begin, and the chair will bring the
user back to the home position.
1. Smart Wake Up Timer
Press this button to activate an air massage program. It is a wonderful all round air massage for gentle
relaxation and loosening of muscles.
4. Relax
Press the stretch button to activate a slightly harder massage that gives special attention to your spine
by slowly stretching it at different points and releasing stress.
Note:
With the air massage in action, should you wish to change the angle of the back or foot rest, the
program will pause and resume automatically once the back or foot rest movement is completed.
5. Stretch
On pressing the On/Off button, a light will tell you that the chair is in the idle functioning mode and will
commence a massage program when you press any other function button. If during a massage
function program, should you wish to suspend for any reason, please press the On/Off button and the
program will cease.
3. On/Off button
On pressing the ZGR button, the back rest, foot rest, and seat will be automatically adjusted to preset
reclining angles.
The reclining motion can be stopped by pressing either the ZGR button, the back rest recline/restore
button, or the foot rest raise/restore button.
After achieving the ZGR position, you may still adjust the angles of the back rest and foot rest by
pressing the relevant buttons.
2. ZGR
Press this button to commence the heating function for the lumbar region. A light will indicate that the
heating function is in operation. Press the button again to cease the function. With the heating function
in operation, should you wish to change the angle of the back rest or foot rest, the heating function will
pause and resume automatically once the back rest or foot rest movement is completed.
6. Heat
Press and hold the M1 or M2 for 2 seconds to create a new memory position.
7. M1 & M2
Press the lumbar button to start a 15 seconds motion, press again to hold the desired support strength, press
a third time to cancel the support gradually.
Lumbar support will stop working if you press the air massage button, and vice versa.
Lumbar support will hold even when the chair turns off, press again or power off to end it. It takes 25 seconds
for air discharge.
8. Lumbar
Press and hold this button until the back rest is at your desired angle. The angle of the seat will move
automatically to match with the angle of the backrest. Movement can be stopped once you loosen the
button.
When activating the back rest, the chair will not simultaneously respond to the foot rest restore/raise action,
heat, and air massage functions.
9. Back Rest - Recline/Raise
Press and hold this button until the foot rest is at your desired angle. Movement can be stopped once you
loosen the button.
When activating the foot rest, the chair will not simultaneously respond to the back rest restore/raise action,
heat, and air massage functions.
10. Foot Rest - Restore/Raise
The chair is programmed to operate for a period of 15 minutes, after which all functions will stop and the chair
will adopt an idle mode in its current position. Note that the heating function is preset to stay on for one hour.
To resume use of the chair after this period, simply press your desired function button.
Automatic Timer
