Step3: Attach seat pad and backrest pad onto the base. Attach the zipper which connect seat pad and footrest. Connect
vibrate wire connector and backrest heater wire connector. (As pictured below show.)
Step 4: Remove the cable tie which fasten the backrest actuator. Remove the cotter pin and remove the bolt. Set the
cotter pin and bolt aside.
Step 5: Attach the backrest onto the base. The backrest must be in a vertical position for the pivot points to properly
engage to base. Have somebody hold the backrest and attach the backrest to the backrest actuator with the bolt and cotter
pin. Attach the backrest cable to the connectors. Attach the air hose.
Step 6: Attach shoulder massage to the backrest. There are four screw holes on each side for attaching the shoulder
Velcro on seat pad and Velcro on the base
must attached perfectly and zip the zipper.
Connect wire connecters.
Remove the cable tie.
Remove the cotter pin and
bolt