3
LOCATION OF DATA PLATE
The data plate is located on the side panel.
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE
All equipment should be examined for damage before and during unloading. The freight carrier
has assumed responsibility for its safe transit and delivery. If equipment is received damaged,
either apparent or concealed, a claim must be made with the delivering carrier.
A) Apparent damage or loss must be noted on the freight bill at the time of delivery. It must then
be signed by the carrier representative (Driver). If this is not done, the carrier may refuse the claim.
The carrier can supply the necessary forms.
B) If concealed damage is not apparent until after equipment is uncrated, a request for inspection
must be made to the carrier within 15 days. The carrier should arrange an inspection. Be certain to
hold all contents and packaging material.
Installation and service should be performed by a qualified installer who thoroughly reads,
understands and follows these instructions.
If you have questions concerning the installation, operation, maintenance or service of this
product, visit Cooking Performance Group’s website at
www.CookingPerformanceGroup.com
.
SAFETY PRECAUTIONS
DANGER
：
This symbol warns of imminent hazard which will result in serious injury or
death.
WARNING:
This symbol refers to a potential hazard or unsafe practice, which could result
in serious injury or death.
CAUTION:
This symbol refers to a potential hazard or unsafe practice, which could result
in minor or moderate injury or product or property damage.
NOTICE:
This symbol refers to information that needs special attention or must be fully
understood even though not dangerous.
NOTICE:
This product is intended for commercial use only. Not for household use.
NOTICE:
Local codes regarding installation vary greatly from one area to another. The
National Fire Protection Association, Inc., states in its NFPA96 latest edition that local
codes are “Authority Having Jurisdiction” when it comes to requirement for installation
of equipment. Therefore, installation should comply with all local codes.
