STEP 1
Thread electrical cord
through the pre-drilled hole
in the skimmer as shown
leaving just enough cord to
maneuver the cover plate
.
Pre-drilled hole
FOR INSTALLATION ON SKIMMER
WITH
PRE-DRILLED HOLE
FOR INSTALLATION ON SKIMMER
WITHOUT
PRE-DRILLED HOLE
STEP 1
On the backside of the cover plate
remove the screw
holding the electrical cord
in place.
STEP 2
With the cord
well out of the way, use an exacto
knife to carefully cut out the channel in the upper lip of the cover
plate
. Pass the cord
through the channel.
STEP 3
Snap cover plate
in place.
Channel
A
B
STEP 2
Slide factory installed
grommet
down the cord and
push through the hole in the
skimmer so that the grommet
plugs up the hole from both
sides.
NOTE: Grommet is not
watertight.
STEP 3
Snap cover plate
in
place.
Interior of
skimmer
Step 4
FOR BOTH TYPES OF INSTALLATION:
Make sure the electrical cord and transformer
are out of the water. Slide plastic O-ring
onto
transformer plug. Insert pins
into transformer
outlet and secure with cap.
STEP 5
The transformer should be plugged
into a GFCI outlet.
MAX
MIN
MAX
MIN
