CPI GP8, Operating Instructions Manual

Place the base of the glass against the 

front three brushes to dry/polish the top 

and bottom of the base.  Using the 

pinching grip place the glass in the 

proper storage vessel.

Turn the unit ’OFF’ and 

REPLACE the dust cover.

Once you have completed 

drying/polishing all of the 

glasses allow the STEMSHINE 

to run for a minimum of 10 

minutes to fluff up the brushes.  

QUICK START OPERATING 

PROCEDURES FOR “STEMSHINE” -

THE  GLASS POLISHER

www.cpishine.com

T:   866-912-3469

Dust Cover

Power ‘On/Off’

Model GP8A

Press the illuminated 

POWER

 button to 

turn on the machine

.  

Wait 10 minutes

to allow the unit to warm up.

Position the unit at waist height on a clean surface -

remove the dust cover. 

FOR ULTIMATE RESULTS, GLASS / STEMWARE SHOULD COME FROM YOUR 

ON-SITE HIGH TEMPERATURE DISHWASHER --  FRESHLY C WASHED.

Lift the glass and place it on one of 

the four outside brushes.  Quickly 

repeat the rocking action for another 

3 to 4 seconds.  Finally, pick up the 

glass using the “OK” grip and then 

pinch the stem of the glass, again 

Place the glass over one of the MIDDLE 

brushes and gently guide the stem of the 

glass.   Gently rock the glass back and 

forth, side to side, for approximately 3 to 4 

Wear the specialized CPI “dimpled” 

polishing gloves,

Lift the glass(es) and place on one 

of the two middle brushes.  Form a 

circle with your thumb and fore-

finger and encircle the stem of the 

glass – the “OK” grip.  This “OK” 

grip should only be used to balance 

the glass -- the glass should rotate 

slightly on the brushes.

DRYING TECHNIQUE

DO NOT APPLY PRESSURE ON THE GLASS OR THE BRUSHES